Tweet
I tried to change the "Always udp 5004" setting as I want to test
the ST approved Mediatrix SIP ATA. I followed the reboot guidelines listed elsewhere to allow dynamic voice packet ports.
After doing this, my polycom IP100 sets would connect to a legacy PBX phone but not pass any sound at all. Anyone had similar results ?
Its the middle of the night, so I cant test all phoneset types
When I re-enabled "Always 5004" the IP100 sets were fine.
the ST approved Mediatrix SIP ATA. I followed the reboot guidelines listed elsewhere to allow dynamic voice packet ports.
After doing this, my polycom IP100 sets would connect to a legacy PBX phone but not pass any sound at all. Anyone had similar results ?
Its the middle of the night, so I cant test all phoneset types
When I re-enabled "Always 5004" the IP100 sets were fine.