Announcement

Collapse
No announcement yet.
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • How To Manually Edit A Switch Due To Being Bricked

    From the console when the switch is booting you will see a prompt to hit any key to break the autoload... i would break the load.

    You should now see a =>

    Then type printenv and a screen like the bottom picture should appear. Take note of your values and save yourself a screen shot to use as reference of your needed values. Every model of switch uses similar values but they are not all the same.... so makes sure you use the exact name acronyms you see in your own switch.

    printenv 90v.JPG

    Above I yellow highlighted the relevant values you need: ipaddr, netmask, gatewayip, host, and serverip
    Please note the example above may very depending on your switch.
    Each switch has slightly different name values. SO Please use the Printenv command to reference your switches required values.

    To set your values manually follow this example (hit return after each line):
    setenv ipaddr 10.10.10.11
    setenv netmask 255.255.255.0
    setenv gateway 10.10.10.1
    setenv host 10.10.10.1
    setenv cntrlsrv 10.10.10.1
    setenv serverip 10.10.10.1
    saveenv 10.10.10.1
    boot



    The Video below is a quick example of this process
    Last edited by Lance; 03-22-2018, 10:37 AM.
    Lance Paddock
    BTX | Business Telephone eXchange
    1(800) 289-0299
Working...
X