No announcement yet.
  • Filter
  • Time
  • Show
Clear All
new posts

  • Adding a route to a ShoreGear switch?

    I need to add the following line in my route table of a Shoregear switch:
    destination gateway flags 3 Refcnt 0 Use 4094 Interface fei0, how do I do it? Thanks in advance

  • #2
    In case anyone is interested the command to do this is:
    routeAdd ("", ""); now when you do a routeShow you will see your new route. This also fixed a problem I was having with oneway audio when calling from the outside trying to talk to a remote ip phone. I did this after telneting to the SG T1. Of course in the routeAdd above you use your gateway ip address.