Sg-90 Briv

[Geordie75]

Hi I was wondering if anyone has had this problem. Just setup a SG-90 BRIV for the 1st time, I gave the switch its ip address through hyperterminal and once I saved it did the reboot opened SD and added the switch iot came up with firmware mismatch so I was told at this point to reboot switch it would go off and get the new firmware from ftp server but this is the message we get and cant do anything with the switch.

Framer Interrupt - Passed
Test summary
All tests passed
Hit any key to stop autoboot: 0
Searching for active link
Found active link on port 1
ENET Speed is 100 Mbps - FULL duplex connection
FTP from server 10.1.120.114; our IP address is 10.1.110.210
Filename 'tskl/uImage'.
Load address: 0x4000000
Loading: ################################################## ###############
################################################## ###############
###
done
Bytes transferred = 1934261 (1d83b5 hex)
passing Linux bootargs: console=ttyS0,19200 mtdparts=NAND0:128k,5m,80m,- version
=1.1.3.18 boot=FTP
## Booting image at 04000000 ...
Image Name: Linux-2.6.16.18shoreV2
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 1934197 Bytes = 1.8 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... Bad Data CRC
=>


Any Ideas?

[Bobby_Digital]

Sounds like a problem with the Forum, probably gonna have to do an update.

[Bobby_Digital]

Anyway, you also need to give the switch (through hyperterminal) subnet mask, gateway, FTP (shoretel) Server, tell it to BOOT FROM FLASH, and turn DHCP off. The V switches also have options for configuring DNS and Domain name too.